Risultati di ricerca
6 giorni fa · Webcams Not Displaying in Mainsail. I'm using the 0xD34D fork of klipper, with moonraker, mainsail, and octoeverywhere installed on a raspberry pi 4b (1gb) (raspbian bullseye, via kiauh ). I'm trying to use a Logi Quickcam Communicate STX, and I've also tried a Rocketfish HD Webcam. The cameras works fine in guvcview, but not in mainsail.
2 giorni fa · I have got to the point of creating my Klipper.bin and attempting to flash it to my printer. I am using a 8gb official SD card. However it is not working, whenever I insert the SD card and tun on my printer it gets stuck on the falling blocks screen and doesn't even show up the loading bar.
1 giorno fa · Can not focus camera. Hello I have tried many variations of v4l2ctl: parameters and values and I cannot get it to work. Camera is on but blurry. I spent the whole day trying and troubleshooting shooting. Here is one conf and log. This is a typical default config. for details to configure to your needs.
22 mag 2024 · Sineos May 22, 2024, 3:39pm 4. These Filament Motion sensors follow a pretty simple logic: If the extruder is advancing, then (within the given timeout) the logic is expecting pulses from the sensor. If the pulse is received then the timeout counting is reset, if not, it executes its runout routines.
5 giorni fa · Activate firmware retraction in your slicer. Activate firmware retraction in klipper : [firmware_retraction] retract_length: 0.8 retract_speed: 60 unretract_extra_length: 0 unretract_speed: 60 Slice the test. Print it and at the start of the print execute this command in the terminal : TUNING_TOWER COMMAND=SET_RETRACTION PARAMETER=RETRACT_LENGTH START=0 FACTOR=0.05 this test will test retract ...
6 giorni fa · Basic Information: Printer Model: Flying bear 6 Host / SBC: orangepi zero 2 Hello guys, I’ve tried to install klipper_host_mcu services by official guides, but when i tried to flash it, I didn’t find this file in tmp…
6 giorni fa · Describe your issue: Similar to M18 not turning off motors with Replicape · Issue #62 · Klipper3d/klipper · GitHub. Disable motors does not work with Replicape on latest klipper, worked on Klipper v0.11.0.
