Risultati di ricerca
PUBLICATION NUMBER. Installation Instructions. 1734-IN028. User Manual. 1734-UM016. Find more technical documentation for this product in the Technical Documentation Center .
- 1734-IN028 POINT I/O One-piece Terminal Bases - Rockwell Automation
Publication 1734-IN028A-EN-P - June 2006 Installation...
- 1734-SG001G-EN-P POINT I/O Modules Selection Guide
The 1734-ACNR adapter features include a variety of control...
- Cut Sheet 1734-TOP - Rockwell Automation
Cut Sheet 1734-TOP. 1734 POINT I/O. 1734-TOP. POINT I/O...
- 1734-IN028 POINT I/O One-piece Terminal Bases - Rockwell Automation
- Important User Information
- Summary of Changes
- New Information
- Revised Information
- Output Modules
- About This Chapter
- Explosion Hazard
- Prevent Electrostatic Discharge
- Install the Removable Terminal Block
- Remove a Mounting Base
- 1734-OW4 Modules with Load Powered by External Power Wiring Diagram
- 1734-FPD Field Potential Distributor Module
Solid state equipment has operational characteristics differing from those of electromechanical equipment. Safety Guidelines for the Application, Installation and Maintenance of Solid State Controls (publication SGI-1.1 available from your local Rockwell Automation sales office or online at http://literature.rockwellautomation.com) describes some i...
This publication contains new and revised information not in the last release.
See the table that shows what we added to this publication.
We updated additional information as necessary to more fully explain certain procedures.
These are features available on output modules. Latching alarms, when set, latch low and high clamp alarm status information. Low and high clamps can be set individually or on a channel basis. When the output value reaches clamp value, a status bit is set, indicating the output is clamped. Disable alarms - disables all channel alarms and faults so...
Read this chapter for installation and wiring information including how to complete the following: Install the mounting base assembly. Install an I/O module. Install the removable terminal block. Remove a mounting base. Wire digital modules. Wire analog modules. Wire power distribution and other modules, such as communication interface modules, fi...
WARNING: Do not disconnect equipment unless power has been removed or the area is known to be nonhazardous. Do not disconnect connections to this equipment unless power has been removed or the area is known to be nonhazardous. Secure any external connections that mate to this equipment by using screws, sliding latches, threaded connectors, or other...
ATTENTION: This equipment is sensitive to electrostatic discharge, which can cause internal damage and affect normal operation. Follow these guidelines when you handle this equipment: Touch a grounded object to discharge potential static. Wear an approved grounding wriststrap. Do not touch connectors or pins on component boards. Do not touch circu...
A removable terminal block is supplied with your mounting base assembly. To remove, pull up on the removable terminal block (RTB) handle. This lets you remove and replace the base as necessary without removing any of the wiring. To reinsert the removable terminal block, proceed as follows. WARNING: When you connect or disconnect the RTB with field-...
2. Rotate the terminal block into the mounting base until it locks itself in place. 3. If an I/O module is installed, snap the RTB handle into place on the module. To remove a mounting base, you must remove any installed module, and remove the removable terminal block (RTB), if wired. WARNING: When you insert or remove the module while backplane p...
Out = Output channel relay contacts Channel Output Common
NC NC CHAS GND CHAS GND V V NC = No Connection CHAS GND = Chassis Ground C = Common V = Supply
- 9MB
- 221
Acquista Base terminale Rockwell Automation 1734-TOPS o Accessori per PLC su RS Online in 24 ore ti consegneremo il tuo ordine con il plus del grande servizio che solo RS può darti.
